한국어 English Chinese Russian
bannerbar

FAQ


No.46 How can I set IP address of ezTCP? 09-12-2011
Category : how to
Category : utility

You can use PC programs for setting of ezTCP. Of course, you can set the IP address of ezTCP with these programs. Following is the list of PC programs.


1. ezConfig, ezConfigMP

Management program via LAN


2. ezSerialConfig

Management program via Serial


3. ezManager

Management program via both LAN and Serial


In case of wireless LAN products, you should set the wireless LAN parameters first with ezSerialConifg or ezManager via Serial port. You can also set the IP address at same way.


* To use ezSerialConfig programs, power on ezTCP without (if it is)W-LAN card.

You could also configure IP address of ezTCP via serial port in "ATC - AT Command" communication mode.
The table below lists the possible method which sets ezTCP equipment parameters the each product especially.



Products ezConfig ezManager AT Command ezSerialConfig ezConfigMP Telnet ezConfigIO
EZL-50 / EZL-50L / EZL-50M / EZL-60 / EZL-60L / EZL-60M / EZL-70 / EZL-200L Ο X Ο X X X X
EZL-200F Ο X Ο X X Ο X
EZL-410 / 400S X X Ο Ο X Ο X
EZL-80 / EZL-80c / EZL-90 / EZL-300L Ο X Ο X Ο X X
EZL-300S Ο X Ο X Ο Ο X
CIE-H10 / CIE-M10 / CSE-H20 / CSE-H21 / CSE-H25 / CSE-H53 / CSE-H55 / CSE-M32 / CSE-M53 / CSE-M73 / CSW-H80 / CSW-M83 / CSW-M85 X Ο Ο X X X X
EZI-10 X X X X X X O
EZI-10 X O X X X X X




See also


Related Products


[ Ethernet-Module ] CSE-M53, CSE-M32, EZL-50L, EZL-50M, EZL-410
[ Ethernet-Module with RJ45 ] CSE-M73, EZL-70
[ Ethernet-Board ] EZL-60L, EZL-60M, CSE-B63
[ Ethernet-External ] CSE-H55, CSE-H53, CSE-H25, CSE-H20, CSE-H21, EZL-200L, EZL-200F, EZL-400S
[ Wireless-External ] EZL-300S, CSW-H80
[ Wireless-Module ] CSW-M85, CSW-M83
[ PPP ] EZP-250, EZU-100, CSP-H50, EZP-EVB, EZU-EVB
[ I/O ] CIE-H12, EZI-10, CIE-H12, CIE-H10, CIE-M10