Q&A

Your information is protected by SSL.

No. 1487	Desactivate Outputs if no connection	2017-05-08

Good afternoon, I would like to know if it is possible to configure the CIE-H10 to do the following: 1. A normal connection is made in Modbus/TCP with the module. 2. Some outputs are activated; 3. Suddenly, the cable information is disconnected or some other line issue breaks the connection between the PC program and the module. 4. All the outputs should be deactivated. I cannot make the module to put all outputs off when there is no connection. I can put all outputs off when I normally disconnect from the module ( I checked the box "Initialize the output port state" in the ez TCP manager). So, is there a way to make all the outputs off if the connection is abnormally lost? Thank you very much.