한국어 English Chinese Russian
bannerbar

Q&A



Your information is protected by SSL.
No. 1568 Re: Re: Re: Re: at+pssl 2018-03-03

When I execute the at+pwp command it returns OK, but after this I do not get any response anymore to any at-command.

When I then power-down/power-up the device. it is working with the ssl setting active.



> Sollae Systems wrote:
> ------------------------------------
> Dear Marc,
>
> The command at+pwp should be used to save the setting to the device.
> After that, to check SSL status, you may use the command: at+pssl?
> In case there is still a problem, could you please let us know more clearly about the situation that those AT commands do not have any effect?
>
> Please feel free to contact us if you have any inquiry.
>
> Thank you for your understanding.
> Best Regards,
>
>
> > Marc wrote:
> > ------------------------------------
> > HI,
> >
> > Thanks for the info. It is indeed the CSE-M53N that I have. I was able to upgrade to this new firmware.
> >
> > Unfortunately the at+pssl does not seem to work. I get OK when I execute the command, but it does not have any effect.
> > Is it a requirement to execute the at+pwp command afterwards. (I only want to change the ssl option temporary)?
> >
> > Regards,
> > Marc
> >
> >
> >
> > > Sollae Systems wrote:
> > > ------------------------------------
> > > Dear Marc,
> > >
> > > This is Technical support team of Sollae Systems.
> > >
> > > Thank you for using our products.
> > >
> > > We would like to make sure that when you mention about CSE-M32N, are you referring to CSE-M32 or CSE-M53N?
> > >
> > > In case you refer to CSE-M32, there is NO beta firmware that supports AT command to activate or deactivate the SSL.
> > >
> > > In case you refer to CSE-M53N, you can get the beta firmware (similar to Q&A 1476) here http://cloud.eztcp.com/201802/CSE-M53N_R20B_07.BIN
> > >
> > > Since this is just a beta version, we have not tested it carefully and we cannot guarantee it works as the official firmware.
> > >
> > > - To check SSL status: at+pssl?
> > > - To activate SSL: at+pssl=1
> > > - To deactivate SSL: at+pssl=0
> > > - To save the setting, you need to send at+pwp command
> > >
> > > You can refer to the page 45 of User Manual to see how to upgrade the firmware. https://www.eztcp.com/en/download/pds_files/csem53nen.pdf
> > >
> > > For more information about AT Command, please refer to https://www.eztcp.com/en/download/pds_files/an_atc_mode_en.pdf
> > >
> > > Please feel free to contact us if you have any inquiry.
> > >
> > > Best regards,
> > >
> > >
> > > > Marc wrote:
> > > > ------------------------------------
> > > > In Q&A 1476 is said that there exist beta firmware for CSE-M32N implementing the at+pssl at command. But it looks like the link is not available anymore.
> > > > How could I get this firmware? (I also need the available to switch ssl on and off with an at-command)

Writer Marc Company I-Explore