한국어 English Chinese Russian
bannerbar

Q&A



Your information is protected by SSL.
No. 47 Re: Ezl 200 F 2005-10-15

Your network diagram like below:
PC(A) -- ethernet -- EZL-200F(B) -- serial -- EZL-200F(C) -- ethernet -- PC(D)

In this case, you can't ping neither PC(D) nor EZL-200F(C) of other side.
Becase those are connected by serial port.

If you communicate from PC(A) to PC(D), you should configure like below:

[EZL-200F(B)]
Permitted IP Address: PC(A)'s IP address or 0.0.0.0
ezTCP Mode: T2S(0)
Local Port: 1470 (arbitrary number you choose)
Timeout: 0

[EZL-200F(C)]
Permitted IP Address: PC(D)'s IP address or 0.0.0.0
ezTCP Mode: T2S(0)
Local Port: 1470 (arbitrary number you choose)
Timeout: 0

Then you should make two TCP connections from A to B and D to C.
(You can use telnet client, Hyperterminal, and etc. for TCP connection.)

If TCP connections are completed, you can communicate from A to D bidirectionaly.

If you want to communicate
> Daniel wrote:
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~
> Hello,
>
> I'm trying to connect 2 PC using 2 ezl 200F and I have some difficulties doing this.
> Each ezl200 is connceted to one PC via the ethernet port and the two ezl200 are connected together through the serial (RS232) port. From one PC, I can ping the ezl200 connected to it but not the other PC neither the other ezl200.
>
> Is it possible to do this ? Can you provide some help or advice ?
> Thank you very much in advance
>
> Best regards
> Daniel.

Writer Sollae Systems Company