Q&A

Your information is protected by SSL.

No. 395	Re: Re: problem after flash EZL50	2007-05-31

Hello The memory is correct but I have progamming only 70%. The soft can't run normally. When I take this in mode ISP, I can't find the EZL with EZconfig with Mac adress or IP adress. I know the latest IP but I can't ping it or take other thing. It enters well in mode ISP but nothing other, that to make? Thanks David > Sollae Systems wrote: > ~~~~~~~~~~~~~~~~~~~~~~~~~~~ > Hello! This is Sollae Systems. > > > Although you don't complete downloading the firmware, you can flash it again. > > If ISP- pin is low, it means ISP operation mode, the [STS LED] have to blink rapidly. > Otherwise, I'm afraid your EZL-50L has some hardware problem. > > I'm afraid EZL-50L doesn't support to flash via serial. Here is supported products list. > EZL-200F, EZL-410, EZL-300S, EZL-400S > > > Thank you. > > > MIRAVETE David wrote: > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~ > > Hello > > > > I have flashing the EZL50L but my network router broke down, only 70% memory is ok. > > The circuit can't work normaly: > > - ISP=0, no leds are high or flashing > > - ISP=1, led flashing but hotplug no work (ezconfig too) > > > > I'm viewing in the datasheet that i can upload by serial port but with which program? > > Can flash this EZL? > > > > firmware newer is 1.1g, old is 1.1f > > > > thanks for all