한국어 English Chinese Russian
bannerbar

Q&A



Your information is protected by SSL.
No. 397 Re: Re: Re: Re: problem after flash EZL50 2007-06-01

Exists it a procedure to give the software in the EZL50L with mode ISP?
Or is this one HS?
Does Y have an address IP of help?

David

> Sollae Systems wrote:
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~
> Hello! This is Sollae Systems.
>
>
> Of course if you completed downloading the firmware, EZL-50L would work properly.
> But your EZL-50L would not work normally regardless of operation mode because you didn't complete downloading the firmware as you told it.
>
>
> Thank you.
>
>
>
> > MIRAVETE David wrote:
> > ~~~~~~~~~~~~~~~~~~~~~~~~~~~
> > Hello
> >
> > The memory is correct but I have progamming only 70%.
> > The soft can't run normally. When I take this in mode ISP, I can't find the EZL with EZconfig with Mac adress or IP adress.
> > I know the latest IP but I can't ping it or take other thing.
> > It enters well in mode ISP but nothing other, that to make?
> >
> > Thanks
> > David
> >
> > > Sollae Systems wrote:
> > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~
> > > Hello! This is Sollae Systems.
> > >
> > >
> > > Although you don't complete downloading the firmware, you can flash it again.
> > >
> > > If ISP- pin is low, it means ISP operation mode, the [STS LED] have to blink rapidly.
> > > Otherwise, I'm afraid your EZL-50L has some hardware problem.
> > >
> > > I'm afraid EZL-50L doesn't support to flash via serial. Here is supported products list.
> > > EZL-200F, EZL-410, EZL-300S, EZL-400S
> > >
> > >
> > > Thank you.
> > >
> > > > MIRAVETE David wrote:
> > > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~
> > > > Hello
> > > >
> > > > I have flashing the EZL50L but my network router broke down, only 70% memory is ok.
> > > > The circuit can't work normaly:
> > > > - ISP=0, no leds are high or flashing
> > > > - ISP=1, led flashing but hotplug no work (ezconfig too)
> > > >
> > > > I'm viewing in the datasheet that i can upload by serial port but with which program?
> > > > Can flash this EZL?
> > > >
> > > > firmware newer is 1.1g, old is 1.1f
> > > >
> > > > thanks for all

Writer MIRAVETE David Company