Q&A

Your information is protected by SSL.

No. 1287	[140917-0001FE] Re: CSE-M53N	2014-10-10

Hello, This is Sollae systems support team. 1. Serial Rx buffer size : 2048 Serial Tx buffer size : 4096 2. When you use UART RTS, RTS is LOW("0") Active signal. It means that if CSE-M53N doesn'st use RTS/CTS, RTS signal should keep HIGH("1"), on the other hands when CSE-M53N use RTS/CTS, it might be LOW("0") Please refer to attached file. 3. CTS is Input pin. "RTS" stands for Request to Send and "CTS" stand for Clear to Send. Before receiving data from user device, CSE-M53N sends LOW signal to user device(CTS). This process is to let the user device know that the module is ready to receive data. [cse-m53n] <----------------DATA-------------[user device] RTS(pin#8) ----------------LOW--------------> CTS In this case, Before sending data to user device, User device sends signal to CSE-M53N [cse-m53n] -----------------DATA------------> [user device] CTS(pin#7) <---------------serial----------- RTS If you have any other question, please do not hesitate to contact us again. Thank you. > PM wrote: > ------------------------------------ > Hi, i have some question about CSE-M53N, respect to CST/RTS > > 1-What is the size of the buffers TX and RX? > 2-The RTS signal, when is "1" and when is "0"? At determined amount of data on buffer? > 3-When i put CTS to "1", the module complete the transmission of the byte in progress and stop? Or how works it? > > Thanks