bannerbar

Support > Technical Support

Q&A

Your information is protected by SSL.

No. 1700	Re: Re: SMG-5420 - No Signals via Modbus RTU	2019-11-13

Works! Thank you for your fast response. Benjamin Beck > Sollae Systems wrote: > ------------------------------------ > Dear Benjamin Beck, > > SMG-5420 device receives Modbus/TCP frame from TCP, converts it to Modbus RTU/ASCII frame and sends it to the serial port, and vice versa. > > Seemingly, the date frame you sent via TCP is the Modbus RTU frame, NOT Modbus/TCP frame. Therefore, It does NOT work. > > You can refer to Mobus/TCP frame in this document https://www.eztcp.com/en/download/pds_files/an_modbus_tcp_en.pdf > > We recommend you to use a Modbus Tool for testing instead of sending raw data for testing. > > For more information about configuring SMG-5420, you can refer to this FAQ: https://www.eztcp.com/en/support/view.php?page=1&cid=484 > > If the problem is not solved, could you please send us via email (support@eztcp.com) the following information: > - The screenshot of SMG-5420's setting > - Modbus configuration of your control unit > > And, is your network topology similar to the scheme in this image https://www.eztcp.com/en/support/images/case1.png ? > > > > > > Benjamin Beck wrote: > > ------------------------------------ > > Dear Madams and Sirs, > > > > I am trying to connect a SMG-5420 device to control unit via ModbusRTU (RS485). Seemingly, the SMG does not recognize any Signals on TX and RX. I am using the following configuration > > > > Bd-rate: 9600 bps > > Data bits: 8 > > Stop bits: 2 > > Parity: None > > SMG working as TCP Server > > Port 502 > > Connection Timeout 60s > > Query Flow: TCP to Serial > > Slave ID 0 > > Response Time: 500 ms > > Send Gateway Exception: Disable > > > > When I try to access the Modbus via EzTerm (or similar tools) and try to send > > > > 15 04 00 02 00 01 93 1E > > > > The connection is terminated. > > > > Trying to emulate a Com-Port via ezVSP didn't either. > > > > Is a 120 Ohm resistor necessary for proper signal termination? What might be the reason for the Modbus Connection problems? > > > > Best regards, > > > > Benjamin Beck > > > > > >

Writer	Benjamin Beck	Company	Nemak