한국어 English Chinese Russian
bannerbar

Q&A



Your information is protected by SSL.
No. 396 Re: Re: Re: problem after flash EZL50 2007-05-31

Hello! This is Sollae Systems.


Of course if you completed downloading the firmware, EZL-50L would work properly.
But your EZL-50L would not work normally regardless of operation mode because you didn't complete downloading the firmware as you told it.


Thank you.



> MIRAVETE David wrote:
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~
> Hello
>
> The memory is correct but I have progamming only 70%.
> The soft can't run normally. When I take this in mode ISP, I can't find the EZL with EZconfig with Mac adress or IP adress.
> I know the latest IP but I can't ping it or take other thing.
> It enters well in mode ISP but nothing other, that to make?
>
> Thanks
> David
>
> > Sollae Systems wrote:
> > ~~~~~~~~~~~~~~~~~~~~~~~~~~~
> > Hello! This is Sollae Systems.
> >
> >
> > Although you don't complete downloading the firmware, you can flash it again.
> >
> > If ISP- pin is low, it means ISP operation mode, the [STS LED] have to blink rapidly.
> > Otherwise, I'm afraid your EZL-50L has some hardware problem.
> >
> > I'm afraid EZL-50L doesn't support to flash via serial. Here is supported products list.
> > EZL-200F, EZL-410, EZL-300S, EZL-400S
> >
> >
> > Thank you.
> >
> > > MIRAVETE David wrote:
> > > ~~~~~~~~~~~~~~~~~~~~~~~~~~~
> > > Hello
> > >
> > > I have flashing the EZL50L but my network router broke down, only 70% memory is ok.
> > > The circuit can't work normaly:
> > > - ISP=0, no leds are high or flashing
> > > - ISP=1, led flashing but hotplug no work (ezconfig too)
> > >
> > > I'm viewing in the datasheet that i can upload by serial port but with which program?
> > > Can flash this EZL?
> > >
> > > firmware newer is 1.1g, old is 1.1f
> > >
> > > thanks for all

Writer Sollae Systems Company