한국어 English Chinese Russian
bannerbar

Q&A



Your information is protected by SSL.
No. 511 Re: Re: CIE-10 and Serial RS232 2009-05-29

Thanks for your answer

It'ss OK now, it works :

[Serial Device]-----(RS232)-----[CIE-H10]-----(LAN)------[ezVSP in PC)]

is for me :

[PIC 16F870]-----(RS232)-----[CIE-H10]-----(LAN)------[ezVSP in PC)]

I send and receive datas from the PC with the software profilab-expert 4.0

now it'ss ok, when i launch my program (profilab-expert), i see the virtual port i created becomes active in ezVSP (9600 bauds...) and the datas are transfered from my PC to the PIC via LAN (or reverse) without problem.

CIE-H10 = Nice devices !

I'sm a electronics teacher and my students will soon use it !

Stephane
FRANCE (Bretagne)





> Sollae Systems wrote:
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~
> Dear,
>
> I'sm sorry, but I didn'st understand you system.
>
> Can you explain that in detail?
>
> If you use the CIE-H10 as a serial device server, the system will be formed like this
>
> [Serial Device]-----(RS232)-----[CIE-H10]-----(LAN)------[ezVSP in PC)]
>
> In this system, a Port of ezVSP and CIE-H10 has to be connected on TCP/IP.
> That means if the CIE-H10 is being operated as client (COD mode), ezVSP should be a TCP server.
> And the peer port of CIE-H10 should be set to your PC'ss IP address. The ezManager let you do that.
>
> In addition, the serial port parameters (baud rate, stop bit, data bit and parity bit) which are shown on ezVSP depend on your terminal program. Please check the status of you program.
>
> Let me know if you can'st carry on or understand anything in above.
>
> And here is download links of newest version of ezVSP and ezManager. Try to use those programs.
> ezVSP_3.2A
> ezManager_3.1E
>
>
> Thank you.
>
> Best Regards,
>
>
>
> > Stephane wrote:
> > ~~~~~~~~~~~~~~~~~~~~~~~~~~~
> > Hello
> >
> > I try to make a communication between a CIE-H10 and a PIC (16F870)
> >
> > I created a virtual port and i try to send (and receive) datas from my PIC to the CIE-H10...
> >
> > I followed the ezVSP User'ss Manual
> > ( Version 2.2c )
> >
> > I use profilab-expert 4.0
> >
> > My pic is configurated 9600 bauds, 8 bits
> >
> > CIE : Telnet, TCP Client, Remote Port 1479
> >
> > Is this configuration possible ??...
> >
> >
> > When I start (open the PORT - COM5) it indicate 115200-8-None-1
> > My PIC cannot go this speed...
> >
> > Can you help me please ?
> >
> > Thanks
> > Stephane-FRANCE

Writer Stephane Company