한국어 English Chinese Russian
bannerbar

Q&A



Your information is protected by SSL.
No. 1794 Re: Re: Re: Reset Ezl 70 2021-03-23

Dear Marco Montorsi,

In order to use AT command, firstly, EZL 70 must be set to "AT Command - ATC" mode.
Did you set the EZL 70's communication mode to "AT Command - ATC" mode?
If not, please set it via ezConfig.

And please note that the AT command should be sent via Serial Interface (COM port).
It is not a TCP protocol


> Marco Montorsi wrote:
> ------------------------------------
> The issue was due to a bad power supply, which wasn't giving 5V but a little bit less, thank you for your response, now i have the problem to command the EZL 70, when i try to use AT command it doesn't work;
First of all i create a telnet connection and the yellow led stays on, so i am sure the connection is established, from what i read i should use the command AT+PSE with final '', to switch to command state, but when i give this command in input, the EZl 70 doesn't return nothing, i can't quite understand the switch between command state and online state,
Thanks,
MM

Writer Sollae Systems Company Sollae Systems