한국어 English Chinese Russian
bannerbar

FAQ


No.75 How can I send data to multiple servers. (UDP broadcast) 09-12-2011
Category : how to

As a RS485 network if you wish to send data to multiple systems at the same time, try to use UDP with broadcast IP address.

ezTCP supports the UDP communication mode.
In the case of EZL-50 and EZL-60, download UDP(U2S) firmware using HotFlash, and in the other products, set UDP(U2S) with a setup program such as ezConfig.

Since broadcast IP differs depending on the network environment,
make inquiry through the question-and-answer bulletin board.
(Your question should include local IP, subnet mask and gateway IP.)

The following is a setting example.

Setting example



ezTCP Mode UDP
Local IP Address 192.168.0.200
Subnet Mask 255.255.255.0
Gateway IP Address 192.168.0.1
Peer IP Address 192.168.0.255 (broadcast IP)
Local Port 1470
Interval(10ms) 0
Block(Byte) 0
Peer Port 1470


[PC #1]


Local IP Address 192.168.0.2
Subnet Mask 255.255.255.0
Gateway IP Address 192.168.0.1
Local Port 1470


[PC #2]


Local IP Address 192.168.0.3
Subnet Mask 255.255.255.0
Gateway IP Address 192.168.0.1
Local Port 1470


[PC #3]


Local IP Address 192.168.0.4
Subnet Mask 255.255.255.0
Gateway IP Address 192.168.0.1
Local Port 1470




See also


Related Products


[ Ethernet-Module ] CSE-M53, CSE-M32, EZL-50L, EZL-50M, EZL-410
[ Ethernet-Module with RJ45 ] CSE-M73, EZL-70
[ Ethernet-Board ] EZL-60L, EZL-60M, CSE-B63
[ Ethernet-External ] CSE-H55, CSE-H53, CSE-H25, CSE-H20, CSE-H21, EZL-200L, EZL-200F, EZL-400S
[ Wireless-External ] EZL-300S, CSW-H80
[ Wireless-Module ] CSW-M85, CSW-M83
[ PPP ] EZP-250, EZU-100, CSP-H50, EZP-EVB, EZU-EVB
[ I/O ] CIE-H10, CIE-M10