한국어 홈페이지 English Chinese
Support

Q&A



Your information is protected by SSL.
No. 1487 Desactivate Outputs if no connection 2017-05-08

Good afternoon,

I would like to know if it is possible to configure the CIE-H10 to do the following:

1. A normal connection is made in Modbus/TCP with the module.
2. Some outputs are activated;
3. Suddenly, the cable information is disconnected or some other line issue breaks the connection between the PC program and the module.
4. All the outputs should be deactivated.

I cannot make the module to put all outputs off when there is no connection. I can put all outputs off when I normally disconnect from the module ( I checked the box "Initialize the output port state" in the ez TCP manager).

So, is there a way to make all the outputs off if the connection is abnormally lost?

Thank you very much.

Writer Fábio Oliveira Company Electronica Industrial